A relatively simple, effective method of refinishing hardwood gunstocks is described. Minimal tools required are a small paintbrush, pint of paint stripper, two toothbrushes, single sheets of wet-or-dry abrasive paper in 220 and 440 grits, a tack rag, large artist's eraser, spray can of suitable finish, paper towels, rubbing alcohol and a steam iron. All iron and plastic pans should be removed from wood, old finish removed with a semi-paste paint stripper which does not require a water wash. Use of steel wool is not recommended for removing softened finish as the steel can be embedded in the wood. Use of toothbrushes is recommended instead of steel wool. Wetted paper towels should be placed over dented areas and the hot steam iron applied to raise dents. Cuts and deep scratches can be filled with shellac sticks. Initial sanding should be with the 220 grit paper, working with the grain and using the alcohol to keep the paper from clogging without raising the grain. The eraser is used to back up the 440 grit to avoid uneven finish. Polyurethane varnish is recommended (3 coats), followed by treatment with Duco No. 7. -- AATA